AlienFlight "Classic Narrow" Brushed FC

AlienFlight "Classic Narrow" Brushed FCThis is a historic flight controller! Based on the original AlienWii design by Lance (2013), produced to the highest enterprise grade quality standards in Germany. Every single controller is tested and programmed, FETs are load tested individually. To make it fly, you will need the following hardware: DSM(X) satellite receiver DSM(X) transmitter 100 150mm frame 7 10mm DC motors 50 70mm propellers 400 700mAh battery specifications: ATmega32u4 mcu

This is a historic flight controller!
Based on the original AlienWii design by Lance (2013), produced to the highest enterprise grade quality standards in Germany.
Every single controller is tested and programmed, FETs are load-tested individually.

To make it fly, you will need the following hardware:
- DSM(X) satellite receiver
- DSM(X) transmitter
- 100-150mm frame
- 7-10mm DC motors
- 50-70mm propellers
- 400-700mAh battery

specifications:
- ATmega32u4 mcu
- MPU6050 accelerometer/gyro sensor unit
- 4x 9.5A ESCs, integrated
- USB programmer, integrated
- serial connection for external DSM2/DSMX sat receiver
- bind button
- modular wiring and plugs
- dimensions: 26.7mm x 31.75mm
- weight: 3.6g (without Rx)
- included: receiver cable, JST power cable

IMPORTANT:

To configure basic settings (such as input ranges and receiver settings, you need to edit and compile an Arduino sketch.
You can find the latest sketch here: -> AlienWii Classic Narrow firmware

To fly this FC, you need an external DSM receiver. We recommend the LemonRX DSMX satellite RX.

To use a DSMX sat you must enable DSMX_BIND_11 or DSMX_BIND_22 and the corresponding SPEKTRUM 1024 or SPEKTRUM 2048

defines in config.h file and recompile with Arduino.

for more information, got to the related forum thread:
http://community.micro-motor-warehouse.com/t/alienflight-classic-narrow-interactive-manual/2580
or use the red help button below to send us a message!