Robo Legs for the RoboLifter *sold in a pair* (Black Plague)Robo Legs for RoboLifter Adjustable Aluminum Legs for Straight PDR Pulls Overview Robo Legs are a precision upgrade designed for use with the RoboLifter, K Beam, and K Beam Junior systems. Built from lightweight aluminum and sold as a pair, these adjustable legs give PDR technicians the ability to correct pulling angles and achieve a true straight pull, even on complex panel shapes. Vehicle panels are rarely flat. Body lines, curves, and structural

Robo Legs for RoboLifter | Adjustable Aluminum Legs for Straight PDR Pulls

Overview

Robo Legs are a precision upgrade designed for use with the RoboLifter, K-Beam, and K-Beam Junior systems. Built from lightweight aluminum and sold as a pair, these adjustable legs give PDR technicians the ability to correct pulling angles and achieve a true straight pull, even on complex panel shapes.

Vehicle panels are rarely flat. Body lines, curves, and structural reinforcements can push your lifter off angle, forcing your pull slightly sideways instead of straight up. That small misalignment can reduce pulling efficiency and increase the chance of glue failure.

Robo Legs solve this problem by allowing you to level and adjust your lifter so the force stays centered directly over the dent. This gives you more consistent pulls, better glue performance, and cleaner results.

Why Straight Pulling Matters in PDR

In glue pulling, small details make a big difference. Even a slight angle in your pull changes how force is applied to the tab and glue.

A pull that is off by just a few degrees can:

• Tear the glue bond early
• Snap the tab neck before full force is reached
• Shift the dent instead of lifting it
• Reduce overall pulling efficiency

When working with smaller tabs, this becomes even more critical. Precision is what allows the glue to hold and the dent to move correctly.

Robo Legs give you the control needed to keep your pull aligned and centered, helping you get the most out of every pull.

How Robo Legs Improve Your Workflow

These adjustable legs mount directly to your lifter and allow you to fine-tune the height and angle of your setup.

Adjustable Height for Proper Alignment

Raise or lower each side to match the panel surface and keep your lifter level.

Corrects Panel-Induced Angles

Compensates for curves, body lines, and uneven surfaces that would normally push your tool off center.

Improves Glue Performance

A straight pull keeps force centered, helping the glue hold longer and pull stronger.

More Consistent Results

Reduces failed pulls and helps eliminate unnecessary rework.

Material and Build Quality

Robo Legs are made from durable aluminum, giving you strength without adding unnecessary weight to your setup. They are designed for repeated use in both shop and mobile environments while maintaining stability under load.

Compatibility

These legs are designed to work with:

• RoboLifter
• K-Beam
• K-Beam Junior

Each set includes two legs, which is the required amount for one lifter setup.

Product Includes

• (2) Adjustable aluminum Robo Legs

Key Features

Adjustable Height Design

Dial in the perfect position for a straight, centered pull.

Improves Pull Accuracy

Keeps force aligned directly over the dent.

Reduces Glue Failure

Helps prevent tearing or premature release during pulls.

Lightweight Aluminum Construction

Strong, durable, and easy to handle in daily use.

Fits Multiple Lifter Systems

Compatible with RoboLifter, K-Beam, and K-Beam Junior.

Perfect For

• Glue pulling with small tabs
• Hail repair
• Curved or uneven panels
• Situations where lifters sit off angle
• Technicians who want more consistent pull results